het staat beschreven (summier) in de hayness manual
Cabriolet models
Removal 8 Remove the door trim panel as described in Section 11. 9 Carefully peel back the waterproof sheet from the door. 10 Remove the door weatherstrip and rubber end block. 11 Lower the window and, working through the aperture, disconnect the linkage arms from the bottom rail. 12 Lift the glass upwards from the door.
[b]Refitting[b/] 13 Refitting is a reversal of removal, but adjust the window stop as follows. 14 Loosen the adjustment bolt, then raise the window until the top edge of the glass touches the top guide seal (see illustration). Now position the stop on the regulator mechanism and tighten the bolt. Check that, with the door shut and the window fully raised, the top front corner of the glass is under the lip of the weatherstrip. Make any final adjustments as necessary.
|